Videos
for Blaylock Industries
Help Articles
for Blaylock Industries
Expert Answers
for Blaylock Industries
Yes, the Redarc Tow Pro Liberty part #RED52VR can install in your 2023 Ford Ranger that has the factory 7-way. It would wire directly to the brake controller install wiring that is present under the dash.
view full answer...Thank you for sending the photo! While I have a solution for you, the Blaylock Total-Encasement Coupler Lock, part #BLTL-23 will not work. I is designed to fit Bulldog Collar-Lok style couplers that use a 2-5/16" ball, like #BD028463 for…
view full answer...I searched online for your 2018 Big Tex and found a picture of it with the EZ Lock Gooseneck Coupler Lock Combo #BLTL-53-40D2 installed so we know this will work well for you!
view full answer...The torque for the Dexter Trailer Hub and Drum Assembly - 6,000-lb and 7,000-lb Axles - 12" - 5 Spoke Utility #8-174-5UC3 is not specified by the manufacturer. For 9/16 inch studs, the typical lug nut torque will be 120-140 ft lbs based on…
view full answer...We only carry the springs for those heavy duty style ramps. For the springs we have the Ramp Spring - 2K Torque for 1-1/2" Shaft - left hand #RS16933LH and corresponding right hand #RS16933RH. The other parts will need to be either…
view full answer...Yes, all you'll need to do is disconnect the three wires running from the converter section in your Progressive Dynamics 4100 #PD4135K from the AC distribution panel (circuit breaker, ground bus bar, neutral bus bar). This will cut the…
view full answer...I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…
view full answer...When the battery dies on the Galeo Pro GPS Tracking Device #GA94FR you have to replace the sensor as they do not offer a replacement battery. The battery is hardwired into the unit and not something that can be replaced.
view full answer...The Oil Cap Kit #RG04-250 is designed for standard 10K - 12K axles and has 3-3/4" diameter threads. This should do the trick for you but I do recommend measuring the diameter of your oil cap first as I wasn't able to find anything related to…
view full answer...Sure thing! The EZ Lock Trailer Coupler Lock #BLTL-20 is for Bulldog Collar-Lok-style couplers while the EZ Lock Trailer Coupler Lock #BLTL-33 is designed for Fulton, Shelby, Dutton-Lainson, Atwood, and similar couplers. I've attached some review…
view full answer...While the Rack'Em Fitz-All Enclosed Trailer Ladder Rack #RA-28 was designed to fit on trailer with a rain gutter, we have had several install it on their trailer without rain gutters. I have also included our review video below where you can see…
view full answer...Based on how tight of clearance there is between the MultiPro tailgate and the rear hitch of the new Chevy trucks I can tell the Curt ball mount part #C43JR would not work with it. Best option is the B and W Tow and Stow part #BWTS20066BMP which was…
view full answer...
What our customers are saying:
"very easy to shop"